Portal Home > Knowledgebase > Windows VPS Hosting > Configuring additional IP in Windows Cloud


Configuring additional IP in Windows Cloud




After logging in, check your network settings. In MSDOS prompt type the command: ipconfig / all.

 

Cloudwin-ipadicional1

 

Write down the data of the network interface that contains the active IP: IP Address, Subnet Mask, Default Gateway and DNS Server. In the example above would be:

Interface Name: Local Area Connection 2

 

  • IP Address: 187.33.2.212
  • Subnet Mask: 255.255.254.0
  • Default Gateway: 187.33.2.1
  • DNS Server: 187.0.192.172



Close the MSDOS prompt and continue the configuration with a hand additional IP data provided by the key (in the example será187.33.0.4).

Click Start >> Control Panel >> Network Connections >> Local Area Connection 2 (in this example is the active network interface). This name can be changed, so check which is the active interface on the output of the command "ipconfig / all" to prompt the "MSDOS".

 

 

Cloudwin-ipadicional2

 

 

Opens the window below, then click "Properties":

 

Cloudwin-ipadicional3

 

 

Select the option Internet Protocol (TCP / IP) and then click "Properties":

 

Cloudwin-ipadicional4

 

 

Complete the following box with the data that you noted in the output of the ipconfig / all and finally, click the "Advanced ..." to configure additional IP:

 

Cloudwin-ipadicional5

 

 

In the "Advanced TCP / IP Settings" click "Add ..." in the IP address field. Will open a second box (TCP / IP Address) requesting additional IP and Subnet Mask.

Fill in the IP data by copying the Subnet Mask of the main IP. In the example below is 255.255.254.0, and then click "Add":

Cloudwin-ipadicional6

 

 

 

Continue closing all the boxes in the "Ok" button. In late fall the RDP connection. Soon after to test the operation, use the additional IP to connect remote. If you can, setup is ok, then open the MSDOS prompt again and check the command output information "ipconfig / all".

 

Cloudwin-ipadicional7

 

As shown above show the two server IPs.

NOTE: To set more than one additional IP, suffice to replicate the process by following the same logic.



Was this answer helpful?

Add to Favourites Add to Favourites    Print this Article Print this Article

Also Read